352 Bored & Stroked!!!

[torquemonger]

hello all ford fans!!! hey i'm looking for anyone who's built a stroker with the stock 352 block. i'm looking to (future) built a nasty tire shredder out of the original motor. anyone got tips and addvice its always appreciated!!!

[convincor]

Did one for the Cobra. Started as a 64 352. Bored to std. 390 bore(4.05") and used the 390 crank.
Forged SpeedPro flat tops, Edelbrock heads out of the box, Blue Thunder intake, Comp XE274 cam, Erson roller rockers..
Ran real good.

[torquemonger]

thanks for the response. do you know off hand what kind of torque and hp that it put out? eventually i'd like to build her up and im just wondering. right now she runs good but burns some oil and is a little tired. thanks again

[Redcap]

thanks for the response. do you know off hand what kind of torque and hp that it put out? eventually i'd like to build her up and im just wondering. right now she runs good but burns some oil and is a little tired. thanks again

I've been thinking about the same thing. 352 bore and a 428 crank, makes a roughly 400ci motor. How much torque/hp will depend on compression ratio, cam, intake/exhaust manifolds.

[torquemonger]

i'm just looking for a rough estimate thats all. never built an engine so im trying to research all the different aspects to get a good idea of where i'll end up. thank you for your response, always appreciated i want to build her up to make some good torque!!! go figure.